...
▲
favorite
favorite
hide
unhide
flag
flagged

Posted

Contact Information:

print

International Scout (preproduction) - $1,234

‹ image 1 of 17 ›
International Scout (preproduction) 1
International Scout (preproduction) 1 thumbnailInternational Scout (preproduction) 2 thumbnailInternational Scout (preproduction) 3 thumbnailInternational Scout (preproduction) 4 thumbnailInternational Scout (preproduction) 5 thumbnailInternational Scout (preproduction) 6 thumbnailInternational Scout (preproduction) 7 thumbnailInternational Scout (preproduction) 8 thumbnailInternational Scout (preproduction) 9 thumbnailInternational Scout (preproduction) 10 thumbnailInternational Scout (preproduction) 11 thumbnailInternational Scout (preproduction) 12 thumbnailInternational Scout (preproduction) 13 thumbnailInternational Scout (preproduction) 14 thumbnailInternational Scout (preproduction) 15 thumbnailInternational Scout (preproduction) 16 thumbnailInternational Scout (preproduction) 17 thumbnail
1971 international scout
condition: fair
cylinders: 8 cylinders
drive: 4wd
fuel: gas
odometer: 100,000
paint color: yellow
title status: clean
transmission: manual
type: truck
odometer broken
odometer rolled over

QR Code Link to This Post

1971 International Scout II prototype (Pilot). Quite rare! Currently listed on eBay. This is one of group of pilot scouts assembled and sent to International Harvesters proving grounds in Phoenix Arizona. It is configured as a travel top with 345 V8 engine, 4 speed manual transmission and Dana 20 transfer case. The numbers for the body, frame, engine, transmission and axles match the original IH build sheet referred to as a Line Setting Ticket. This was my daily driver back in 2003 in Arizona. It is currently not running and was in process of restoration when I moved from Arizona.

The last couple photos are prior to beginning the restoration. Rust repair was completed in the front floor area with new metal back in 2003. The rest of the body including rocker panels is very clean. Bodywork is not complete but primed just to protect areas of bare metal. Completed so far have been the frame, leaf springs, axles, brakes, transfer case and transmission. I believe the engine spun a cam bearing. It spun freely when pulled and sat in the garage since 2004. It now only turns freely for about 3/4 rotation. This is a great project with potential high dollar value. I may consider partial cash and trade. (FJ,Wrangler,Bronco)

You can respond through CL email preferred or
Leave message at 928-eight three zero four eight one zero. Thank you for looking.

https://www.ebay.com/itm/206173906608

post id: 7924088024

posted:

updated:

♥ best of [?]

loading
reading
writing
saving
searching

refresh the page.